January 31, 2012

#184- How to Replace a Bathroom Exhaust Fan

As you saw yesterday, my superhero hubby cleared the Downstairs Bathroom of all it’s disgusting glory, so it was my turn to get working on the  “in the walls” projects before we put this baby back together.  We started at the top, quite literally, with the exhaust fan and light.




Let me start by saying that these types of fans are meant to be installed before a ceiling even goes into a space, so if you already have a ceiling in, and you don’t have access to an attic space directly above your fan, think twice about trying to replace that bad boy, because it’s going to be tricky.  And by tricky I mean it sucks.  Big time.

Unfortunately we didn’t have a choice.  Not only was the housing yellowing with time, but the fan made a noise like a pair of maracas in an mariachi band.  All of this maybe I could have tried to fix without removing it, but the biggest problem with this guy is that there was no duct work attached to it.  As in, it was venting condensation and air into the space between the bathroom ceiling and the floor of the kitchen.  Genius, right?  Thankfully, we discovered this only by luck when we had to rip open the bathroom ceiling to replace the frozen plumbing before we bought the house.  



Let me back up and give you the short version.  We put an offer on the house, waited 7 months to hear back from the bank, finally we got approval and went in for the inspection, all the pipes had frozen while we were waiting and burst, our bank wouldn’t give us a mortgage without working plumbing, the bank that owned the house wouldn’t fix it, and we couldn’t legally fix it because we didn’t own it.  So we may have accidentally let ourselves in to the vacant house and accidentally fixed the plumbing anyway.  And to the surprise of our mortgage company, all the plumbing was fixed when they sent their appraiser over.  Shh- don’t tell anybody. :)

So back to the story at hand, when Super Dad broke into was in the house with us and patching that part of the ceiling, he just happened to look around in there and realize that there was no ventilation attached to the fan.  For thirty years that fan had been blowing moisture into the rafters.  We’re lucky that none of the beams were starting to warp or rot. In order to fix it, I was going to have to cut a pretty big hole in the ceiling to
thread through and attach new duct work, so while I was at it I just replaced the whole thing.

These fans are usually attached to the rafters, or to a set of suspension braces in-between rafters.  Which means the only way to get to the screws to remove it is to cut a larger opening in the ceiling.  (Unless you have access through an attic, you lucky dog.)



And to add insult to injury, the builders tapped this guy in with nails instead of screws, so cue about 30 minutes of prying and cursing trying to get this clunky piece of garabage out of the ceiling.






Once it was out, I first worked on running through the new duct work.  Luckily, my furnace room is right next to my bathroom, so I only had to get the duct work through the ceiling over into the furnace room, and then I could vent it out to the exterior of my house from there.  Here’s my 4” wide flexible ducting, I needed a 25’ piece.



Yep, that thing expands to 25 feet.  No kidding.
I used a fish tape to pull the duct work through my hole into the furnace room.  It’s basically just a long, flexible metal stick that you can unrole as much as you need.  We purchased ours back in The Bungalow when we were running speaker wire through the walls.




Once I had the duct work run, I could attach my wires and put my new fan housing into the ceiling.  I probably should have cut back more of the ceiling to do so, but I didn’t want to have all that patch work, so instead I bent my arm around inside the ceiling like Gumby trying to screw my fan into the ceiling joists.  Screws this time.  Take note 1980’s contractors- screws.



Then I just had to cut a piece of sheet rock to place back into my newly created hole in the ceiling.  I forgot to snap a photo before I put the first round of mud and tape on it, but you get the idea.




Eventually that big patch will be covered up and seamless, but unfortunately I have a few more steps before then. Here’s a closer look at that before ceiling with the messy patch left over from the plumbing incident.  


 
First I'll have to tell you all about fixing the ceiling, and then I can finish putting the rest of the light together.  Rome wasn't built overnight, and this bathroom won't take a DIY 30 minute episode.  But everyday we inch a little closer.  And luckily we have a warm, heated, automatic toilet to sit on in the mean time.

10 comments:

  1. We just replaced the exhaust fan in our guest bath this weekend. It was also venting into the rafters- not good. It was a massive pain in the booty and I am glad it's over!

    ReplyDelete
  2. What a coincidence Jo! How did you vent it to the outside? Did you have attic access or did you have to cut through the ceiling and walls?

    ReplyDelete
  3. We wrapped up a bathroom overhaul a couple weeks ago, and I had grand plans to replace the fan. Well, hubs started taking the old fan out as I was reading the directions for the new fan installation, and before he got any further than the cover, we decided that it just wasn't worth it for a half bathroom in the basement...so we washed it up, put it back, and called it a day. We'll explore that wonderful project when we get to the full bathrooms upstairs (attic space above).

    ReplyDelete
  4. Good choice Amanda! That's 3 days of my life I'll never get back!

    ReplyDelete
  5. AnonymousJune 16, 2012

    I so wish I had read this before I bought a new (bigger and quieter) fan and then ripped the old one out this morning. Had no idea I'd have to mess with replacing part of the drywall and repainting the ceiling.... :(:( No wonder the contractor wants $350 for the work.

    ReplyDelete
  6. That big patch messed up you ceiling pretty bad, Erin! You should do something about it. Anyhow, having a properly ventilated bathroom is substantial. In a way, it eliminates odor, keeps the bathroom dry, and prevent molds and mildew from building up.

    ReplyDelete
  7. I really needed to find this post. I have a bathroom that started life as a walk-in closet, and it was the cheapest conversion they could come up with. I have addressed almost everything (no heat vent, no electrical outlet, improperly wired lighting .... ) but the condensation on the outer wall when anyone takes a shower indicates the need for a higher capacity exhaust fan. I was hoping to not have to cut into the ceiling, but now that I know I can at least be prepared for the inevitable. Thanks for the information!

    ReplyDelete
  8. Hello,
    Nice post...Its quite helpful for me..I got the trick of replacing ducted bathroom fans...Keep posting...Thank you too much.......

    ReplyDelete
  9. Electric technology is revolutionizing our lives, from efficient home appliances to sustainable transportation solutions. Embracing electric innovations can significantly reduce our carbon footprint and energy costs. As we advance, integrating electric solutions into daily life will contribute to a cleaner, greener future. Exciting times lie ahead with these advancements!

    ReplyDelete