Cabin Fireplace Part 7- Building the Mantel

For those of you still with me as I get get lost on this crazy house journey, thank you. I owe you good, fun, quality project updates, so let's take my mind off my house-reno-that-never-ends and head to my happy place; our cabin up north.

When I last left you we had created a stacked stone fireplace and all that was left was the mantel. I had initially built a frame out of 2x4s, but once that big, beefy stone was in it was clear my whimpy mantel wasn't going to cut it.

It wasn't going to be easy though, as no one on the internet seemed to have my same odd configuration for a mantel. So I fell asleep a few nights building and rebuilding it in my head, until I came up with this crazy configuration. I built it out of scrap studs in our garage, (those red boards are left over from the addition-that-became-a-brand-new-deck project. )You'll see that I had to make 2 boxes, one that fit in between the shelves, and one slightly wider one that could stick out over the fireplace rock.

You might also notice that the back box was 1/2" taller than the front one.

Here's why- so I could fit a 1/2" piece of plywood on top.

Or on the bottom that is. Once I attached the plywood, I flipped over the entire piece, so that the 1/2" plywood stuck out from the fireplace on the bottom of the mantel for a nice, clean look.

Then I wrapped the sides with 1x8's, mitered to a nice perfect corner. (I only had to cut it about 7 times to reach perfection.)

I built the sides to be 1/2" taller than the studs, so that I could set in a 1/2" sheet of plywood to complete the top.

You'll notice we have cables running behind the TV wall, and if you look close you can see in this pic the hole we drilled where the wires go from this area to the built in shelf on the left. We'll put the last piece of barn wood up with screws so that we can always remove this piece if needed to adjust the cords.

Now that my little Frankenstein was complete, it was time to finish it. I went back and forth a million times, and finally stained a scrap piece and let the family vote.